Lawn Mower Machine-3
Post Time: 2016-08-02
preparation work
Before mower operation must be carried out a series of checks and preparation. The
machine stops in a horizontal position, first check the fuel tank and
cooling water tank, open the tank cover, according to the manual
requires adding an appropriate amount of cooling water, cover the
radiator cap, open the fuel tank cap, added fuel to meet the
requirements, the fuel will not increase too full ,
cover and tighten the fuel tank cap, check the tire pressure is normal,
is insufficient to promptly inflated, check the cutting disc is in
normal operation, the cutter is intact, each belt should be no cracks,
pinch roller and effective work, otherwise they will be promptly
replaced or adjusted. The
gearbox clutch lever, clutch lever cutters are placed in separate
locations on the gear lever in neutral position, the cutter pinch roller
is released into the walking position, the throttle lever into the
middle position to start the engine cranks after starting slowly throttle, gearbox clutch lever pushed to the binding site. Then
mount low forward gear, lawn mowers began to walk, at the close from
the village where jobs mower can walk on their own destination, because
this mower walking slower, if compared with the distance far, should also have the job of transport.
When
the lawn mower came headland, to stop the machine, make further
adjustments, tread two walk round this machine can be adjusted, we take a
look at the side of the tire is connected via a plug in the drive shaft ,
there are three connector jacks, tire connect different locations, two
different tread on the drive shaft, the grass slope is relatively large,
wide track to better adapt to the ground. The
cutter pinch roller move the working position, according to stubble
height requirements, adjustment of the cutting device, mainly by
adjusting two screws to adjust the position of the cutter height. Tighten the cutter blade connecting screws and tighten the screw connection protective cast. The
two clutches are placed in separate locations linked to the neutral
position and re-start the engine, slowly increase the throttle, the
clutch lever slowly connector cutters, cutting discs start running
together, combined with the gearbox clutch, then mount low forward gear, Mower began to work into the ground.
rjjnicole