Profile cutting machine operating procedures-3
Post Time: 2016-08-03
2)Maintenance(1) by a professional electrician to replace the cutter regularly replace the brushes, blades and check the return spring force is intact. (2) protect the cutter body as a whole is in good condition and clean and remove dirt to ensure that the blade dynamic and smooth transfer. (3) periodic inspection by a professional cutting machine components for damage, serious injury can not be reused should be replaced, repaired. (4) timely addition to the body due to job loss body screw fastener. (5) regularly check the transmission parts bearings, gears and cooling hood, Blade is flexible intact, timely filling oil to the rotating parts, in order to prolong the life of hand drill. (6) after use hand drill to promptly return the tool library for safekeeping. Eliminate personal tool storage cabinet overnight. 5.Safety rules:(1) The operator must be familiar with the performance of equipment, compliance with safety procedures to prevent accidents. Current Affairs work. (2) cutting machines necessary to concentrate, not only to keep a clear head, to be more rational operating power tools tired, drunk or prohibited doping, cutting machine operation after drugs. (3) power line must be safe and reliable, it is strictly prohibited without permission Luanla. Performance of the device must be carefully checked before use to ensure that all parts intact. (4) put on the right clothes, do not wear loose clothes, not to wear jewelry or long hair, wearing gloves and cuff are not prohibited buckle operation. (5) machining a workpiece to be clamped firmly prohibited workpiece clamping is not tight to start cutting. (6) is strictly prohibited on the plane of the wheel, grinding burr of the workpiece, grinding wheel to prevent chipping. (7) during the cutting operation must deviate from the grinding wheel front, and wear protective glasses. (8) Do not use an existing incomplete grinding wheel, should be cut to prevent Mars scattered, and away from flammable materials. (9) clamping a workpiece clamping should be smooth firm, shields must be installed correctly, you should check the air operation after boot setup, without vibration and abnormal noise. (10) a new way to replace cutting blades or grinding wheel piece, do not lock nut too hard to prevent the blade or grinding wheel crack accidents. (11) jitter and other equipment failure, should immediately stop repair, prohibited ill and doping and drink operations, the operator is prohibited to wear gloves. As during operation causes dust, wear a mask or face shield.
rjjnicole