Profile cutting machine operating procedures-2
Post Time: 2016-08-03
3.Related Accessories:(1) special spare parts. (2) blade and locking nut China. (3) synchronous landing glass attached hood.(4) Plug and drag the power cord. (5) brushless motor spare terminal. (6) the level of body positioning instrument. (7) mask or face shield. (8) Auxiliary long workpiece holder.(9) special disassembly and electrical test tools. 4.Use and maintenance1)The correct use(1)Must be carefully checked before the performance of the device (1) use, to ensure the integrity of each member. (2)power knife switch, the tightness of the blade, blade guard or a safety barrier for detailed examination, console must be solid, night work should have enough illumination. (3)Before use, first open the main switch, load test turn a few laps, to be confirmed safe and correct before allowing start. (4)The operator must view is consistent with the conventional power 220VA rated voltage power tools, in order to avoid receiving the wrong 380VA power, not use the rated power of less than 4800 rev / min blade.(5)must hold steady even force vertical cutting machine cut handle and a fixed end to a solid and reliable. (6)Do not attempt to cut saws unclamped small parts or with serious edge profiles (eg outer diameter less than 15 cm). (7)In order to improve work efficiency. Before sawing single or multi-branch together, we must do a good job supporting fixture positioning. (8)may not be powerful sawing operation, you have to wait before cutting the motor speed to reach full speed. (9)Do not allow anyone to stand behind saw, power outages, or leave the rest to work, should immediately cut off the power. (10)shall not release either hand or lift the arm when the blade is not stopped from saw or workpiece.(11)Do not operate when the cover is not in place, the hand should not be placed within 15 cm away from the saw blade. You can not lean over or bypassing saw, when the operation body Xiece 45 degrees is appropriate. (12)There appear abnormal sound, should immediately stop inspection; repair or replacement must first cut off the power before fitting, and the like blade stops completely. (13)using a cutting machine such as when working in wet places, must stand on an insulating mat or dry wood were. Or climb in the explosion dangerous area must use proper safety precautions.
rjjnicole