Angle Grinder Safety Routine Maintenance(a)
Post Time: 2016-07-04
1. Before use, make sure the tools connected to the power supply voltage must comply with the nameplate.2. When the power tool switch should be in the "off" position.3. Before operating, the grinding wheel should carefully check compliance with the provisions of the reinforcing fiber resin grinding wheel used, its safety line speed not less than 80m / s. The outer diameter of the sand transfer shall not exceed the maximum size of the tools provided. At the same time there should be a cracking sound application mallet when tapping wheel. Before use if used for preservation of the wheel more than a year, it must first rotation strength test qualified.After the first test run grinder should look 4. Use, again contact with the workpiece to be machined, the tool has been prohibited in the state in contact with the workpiece direct tool to start the job.5. Use proper anti-wear throughout should wear goggles and appropriate work clothes.6. Do not use in case of removal of the wheel grinder shield.7. Do not move the hand tool when pulling the power cord method, nor the way the hand pulling the power cord from the outlet of the tool method, doing so may cause power lines to break, resulting in danger.8. When the tool fails when required maintenance, or the need to replace any parts, should unplug the power plug from the state.4. The grease should be added.
for more spare parts please click here
rjjnicole