Hammer Introduction (c)
Post Time: 2016-06-24
Personal protection when using the hammer
1, the operator must wear protective glasses to protect the eyes, face
upward when the job is to wear protective masks.
2, long-term job fortress
good earplugs to reduce the impact of noise.
3, long after the job is in the
drill burning state, should pay attention to the replacement skin burns.
4,
the job should use the side handle, two-handed operation, to prevent the
reaction sprained arm when stall.
5, standing on a ladder or work should be
prepared to work at heights falls measures ladder should be ground personnel
support.
Second, it should be careful before operation
1, confirm the site
connected power supply and hammer plate match. It is connected with leakage
protection.
2, with the drill bit holder should be adapted and properly
installed.
3, drilling walls, ceiling, floor time, you should first confirm
whether the laying of cables or pipelines.
4, in the high places, to give
full attention to the following objects and pedestrian safety, set up warning
signs if necessary.
5, confirm the hammer switch is off, if the power switch
is turned on, then plug into an electrical outlet power tool will start turning
immediately, which could lead to personal injury hazards.
6, When the work
area away from the power source, the need to extend the cable, use sufficient
capacity, the installation of qualified extension cable. Extension cord, such as
by a pedestrian should do or overhead cables laminated Measures to prevent
damage.
For more power tool please click here
for reference.
rjjnicole